CNC lathe machining is divided into vertical and horizontal according to the spindle placement method. Horizontal CNC machining usually has an indexing turntable or a CNC turntable, which can process each side surface of the workpiece; it can also be combined with multiple coordinates to facilitate Machining messy spatial surfaces. Vertical CNC machining usually does not have a turntable, but only for top surface machining. In addition, there are composite CNC machining with vertical and horizontal spindles, and the spindle can be adjusted to a horizontal axis or a vertical axis. Adjustable CNC machining, they can process the workpiece on five sides.
The common shapes of processing intermediate guide rails are rectangular guide rails and V-shaped guide rails. The horizontal appearance of the rectangular guide rail controls the straightness error of the guide rail in the straight plane. The two peripheral surfaces of the rectangular guide rail control the straightness error of the guide rail in the horizontal plane. For the V-shaped guide rail, Because the guide rail is composed of two oblique surfaces, the two oblique surfaces not only control the straightness error in the straight plane, but also control the straightness error in the horizontal plane.
When using the scraping method to repair the straightness error of the guide rail, most of the research point method is used. The research point method is often used for the detection of shorter guide rails, because the flat ruler is simply deformed when it exceeds 2000mm, which is difficult to make and affects the measurement accuracy. At the same time, the straightness error of the guide rail is usually ensured by the accuracy of the flat ruler. At the same time, there is also a certain demand for the density of the research point per unit area. It can be based on the accuracy requirements in the middle of the processing and the nature and importance of the position of the guide in the middle of the processing. , The separation is stipulated as not less than 10-20 points per 25mm×25mm (the number of points per scraping square).





