Friends who understand precision parts processing know that precision processing is a very strict process, whether for cutting or other processes, or accuracy and size are very strict requirements. So when machining precision parts, what requirements and standards must be followed to ensure low or even zero defective rate?
For precision parts processing, there are mainly dimensional requirements, such as the diameter of the cylinder, there are strict requirements, and the positive and negative errors are within the specified requirements to be qualified parts, otherwise they are unqualified parts; there are also specific and strict requirements for length, width and height. There are also provisions for positive and negative errors. For example, if the diameter of an embedded cylinder (take the simplest basic component as an example) is too large and exceeds the error tolerance, it will cause the situation that it cannot be inserted. If the actual diameter is too large If it exceeds the lower limit of the allowable negative value of the error, the insertion will be too loose and the problem of looseness will occur. These are unqualified products, or the length of the cylinder is too long or too short, which exceeds the allowable error range. They are all unqualified products. They must be discarded or reprocessed. This will inevitably increase the cost.
1. Dimensional accuracy The journal is the main surface of shaft parts, which affects the rotation accuracy and working state of the shaft. The diameter accuracy of the journal is usually IT6-9 according to its use requirements, and the precision journal can reach IT5.
2. Geometric shape accuracy The geometric shape accuracy (roundness, cylindricity) of the journal should generally be limited to the range of the diameter tolerance point. When the geometric shape accuracy is high, the allowable tolerance can be specified on the part drawing.
3. The position accuracy of mechanical parts processing mainly refers to the coaxiality of the matching journal of the assembly transmission part relative to the supporting journal of the assembly bearing, which is expressed by the radial circular runout of the supporting journal to the supporting journal; The use requirements stipulate that the high precision axis is 0.001~0.005mm, and the general precision axis is 0.01~0.03mm. In addition, there are requirements for the coaxiality of the inner cylindrical surface and the perpendicularity between the axial positioning end surface and the axis line.
4. The surface roughness can have different surface roughness values according to the different surface working parts of the parts. For example, the surface roughness of the ordinary machine tool spindle supporting journal is Ra0.16~0.63um, and the surface roughness of the matching journal is Ra0. 632.5um, with the increase in machine speed and precision, the surface roughness requirements of shaft parts will become smaller and smaller.





