+8618007495456

How can CNC milled parts reduce the likelihood of damage?

Aug 16, 2022

How can CNC milled parts reduce the likelihood of damage?

In the processing of CNC milling parts, various presses and special tools installed on the press are used to produce parts of various shapes or required shapes through the pressure of metal materials. Such special tools are collectively referred to as metal molds.

Metal mold life and mold structure design, mold steel selection, heat treatment, surface treatment, machining grinding, wire cutting process, stamping equipment, stamping materials and processes, mold lubrication, maintenance and repair levels and many other factors. Among them, mold failure caused by various factors, unfair mold structure, improper selection accounted for about 25%, heat treatment accounted for about 45%, technical problems accounted for about 10%; equipment problems, lubrication and other factors accounted for about 20%. After installation, the CNC milling parts should be maintained to prevent rust and corrosion. In daily use, the light should be lightly turned off to prevent hard disconnection and hard opening, which may cause damage.

1. The model, specification and performance of the hardware accessories should comply with the current national standards and relevant regulations, and match the selected related products.

2. For some products that are subjected to large forces and are relatively easy to contact with air, corresponding metal materials should be used reasonably.

3. When installing hardware with fastening screws, metal gaskets must be provided, and the thickness of the gaskets should be at least twice the spacing between the teeth of the fasteners. Do not fasten plastic profiles and do not use non-metallic linings.

4. After the CNC milling parts are installed, attention should be paid to maintenance to prevent rust erosion. In daily use, the light should be lightly turned off to prevent hard light and hard turn on damage. Nylon wheels are no longer noisy. It not only pulls up without noise, but also is smoother and lighter; from the surface, the pulley is poor and the workmanship is relatively rough. Non-smooth, non-slip, inflexible, small and light.

When we buy their CNC milling parts in our daily life, if we do not buy this product, we can first observe whether the appearance of the CNC milling parts is abnormal, or whether their products are missing.

If there happens to be gauze, we can clean the surface of the gauze, CNC milling the surface of the part with a gauze towel, and polish the entire surface, if there are pitting, indentation, etc. on the surface, please do not buy the product.

Or our oil testing method to detect it. First of all, we need to clean the surface of the CNC milling part, and then apply a clean brush to the outer surface of the CNC milling part in one direction, plus the CNC milling part enters the light below for testing, then we can easily find the CNC milling part There are pits and ripples on the surface of the piece.

The reason why CNC milling parts cannot meet the required bending height: simply adopt V-shaped bending and L-shaped bending processing, and the size requirement can reach 10±0.1mm. Reason: V-shaped bending, the material between the convex and concave is in a free state, resulting in dislocation. In an L-bend, the radius of the bend, the size of the die radius, and the thinning of the sidewalls result in increased friction to pull the material into the die, increasing the length of the material in the die. Male model reduction.

CNC milling parts are mainly metal or non-metallic sheet presses through stamping dies. It mainly has the following characteristics: CNC milling parts are produced by stamping under the premise of no material consumption, light weight, good rigidity, and metal plasticity inside the sheet metal parts After deformation, the organizational structure is improved, and the strength of CNC milling parts is improved. CNC turning and milling parts have high dimensional accuracy, uniform size and module size, good interchangeability, do not require further machining, and can meet general assembly and use requirements.


Send Inquiry