+8618007495456

How to select tools

Nov 23, 2022

How to select tools

Because the spindle speed and range of CNC machine tools are much higher than those of ordinary machine tools, and the output power of the spindle is also large, compared with the previous processing methods, higher requirements are put forward for CNC processing tools that include high precision, high strength, high rigidity, high durability, high durability, dimensional stability, and easy to set and adjust. This requires proper tool structure, standardization and geometric parameter series connection. CNC tool is one of the preconditions to improve the processing efficiency. Its selection depends on the shape of the processing object, the state of the material, the rigidity of the fixture, and the tool selected by the machine tool.

Consider the following:

1. Select tools according to the cutting performance of parts and materials.

For rotating or grinding high-strength steel, titanium alloy and stainless steel parts, it is recommended to use indexable carbide tools with better wear resistance.

2. Select the tool according to the part processing stage.

That is to say, in the rough machining stage, the stiffness is mainly reduced by removing the finish machining in order to select more accurate tools. In the semi finish machining process, the machining accuracy and product quality of the parts are mainly ensured, but the higher performance and durability of high-precision tools are ensured. The tool accuracy used in the rough machining stage is low. In addition, the precision of the tools used in the finishing table is very high.

If the same tool is selected for rough machining and finish machining, most of the tool edges removed from finish machining will be slightly worn and worn due to coating wear, so it is recommended to select the tool removed from finish machining during rough machining. Continuous use will affect finishing. Processing quality, but has little effect on rough surface treatment.

3. Select tools and geometric parameters according to the characteristics of the machining area.

If the structure of the part is acceptable, the tool with large diameter and small aspect ratio must select the edge of the super center milling tool to cut thin-walled and ultra-thin pendulum parts, and there must be enough centripetal angle to reduce the cutting force of the tool and cutting parts. In the processing parts of soft materials such as aluminum or copper, the end milling cutter with slightly larger angle shall not exceed 4 teeth.


Send Inquiry